3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

414 CHAPTER 23: IKE CONFIGURATION COMMANDS
ike encrypt-card
dh-computation
disabled
Syntax
ike encrypt-card dh-computation disabled
undo ike encrypt-card dh-computation disabled
View
System view
Parameter
None
Description
Use the ike encrypt-card dh-computation disabled command to enable DH
switching through software, but not through hardware.
Use the undo ike encrypt-card dh-computation disabled command to enable
DH switching through hardware.
By default, DH switching is implemented through hardware.
Example
# Disable DH switching through hardware.
[SW8800] ike encrypt-card dh-computation disabled
ike local-name Syntax
ike local-name name
undo ike local-name
View
System view
Parameter
name: Name of the local GW in IKE negotiation, which contains 1 to 32
characters.
Description
Use the ike local-name command to set the name of the local GW.
Use the undo ike local-name command to restore the default name of the local
GW. By default, the name of the security gateway is used as the name of the local
GW.
If the initiator uses the GW name to perform IKE negotiation (id-type name is
used), you must configure the ike local-name command on the local device.
Related command: remote-name.
Example
# Identify the local GW by the configured name "beijing_VPN"