3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

PKI Displaying and Debugging Commands 451
packet: Enables debugging for DVPN packets, such as control packets, data, and
IPsec packets.
Description
Use the debugging dvpn command to enable specified types of DVPN
debugging.
Use the undo debugging dvpn command to disable specified types of DVPN
debugging.
Debugging for DVPN is disabled by default.
Example
# Enable debugging for DVPN register events.
<SecBlade_VPN> debugging dvpn event register
display dvpn ipsec-sa Syntax
display dvpn ipsec-sa { all | dvpn-id dvpn-id [ private-ip private-ip ] }
View
Any view
Parameter
all: Specifies to display all information about IPsec SAs.
dvpn-id: ID of the DVPN domain in the range of 1 to 65535.
private-ip: Private IP address.
Description
Use the display dvpn ipsec-sa command to display information about IPsec SAs.
Example
# Display information about IPsec SAs in the DVPN domain with an ID of 1.
<SecBlade_VPN> display dvpn ipsec-sa dvpn-id 1
---------------------------
Session dvpn-id : 1
Session local : 10.0.0.3
Session remote : 10.0.0.2
sa mode : DVPN
---------------------------
[Inbound ESP SAs]
spi : 1549550209 (0x5c5c4281)
authentication-algorithm : ESP-AUTH-MD5
encryption-algorithm : ESP-ENCRYPT-3DES
life duration(bytes/sec): 0/180
remaining life duration(bytes/sec): 0/102
[Outbound ESP SAs]