3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

452 CHAPTER 25: DVPN CONFIGURATION COMMANDS
spi : 2421434273 (0x905427a1)
authentication-algorithm : ESP-AUTH-MD5
encryption-algorithm : ESP-ENCRYPT-3DES
life duration(bytes/sec): 0/180
remaining life duration(bytes/sec): 0/102
display dvpn map Syntax
display dvpn map { all | dvpn-id dvpn-id | public-ip public-ip }
View
Any view
Parameter
all: Specifies to display information about all established maps.
dvpn-id dvpn-id: Specifies the ID of the DVPN domain. The dvpn-id argument
ranges from 1 to 65535.
public-ip public-ip: Specifies the public IP address.
Description
Use the display dvpn map command to display information about maps in a
DVPN domain, such as private IP address, public IP address, port number, DVPN
connection state, DVPN connection type, and control ID.
Example
# Display information about all maps.
[SecBlade_VPN] display dvpn map all
vpn-id private-ip public-ip port state type control-id
--------------------------------------------------------------------
1 10.0.0.2 211.1.1.2 9876 SUCCESS C->S 70433124
2 11.0.0.2 211.1.1.2 9876 SUCCESS C->S 70432548
display dvpn session Syntax
display dvpn session { all | dvpn-id dvpn-id [ private-ip private-ip ] }
View
Any view
Parameter
all: Specifies to display information about all established sessions.
dvpn-id dvpn-id: Specifies the ID of the DVPN domain. The dvpn-id argument
ranges from 1 to 65535.
private-ip private-IP: Specifies the private IP address (the IP address of the tunnel
interface).
Description
Use the display dvpn session command to display information about sessions
the device owns.