3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

456 CHAPTER 25: DVPN CONFIGURATION COMMANDS
dvpn client
register-interval
Syntax
dvpn client register-interval time-interval
undo dvpn client register-interval
View
System view
Parameter
time-interval: Interval for the client to register, in the range of 3 to 60 (in seconds).
Description
Use the dvpn client register-interval command to set the interval for the client
to register.
Use the undo dvpn client register-interval command to restore the default
interval for the client to register.
The DVPN client initiates a request to register with the server. If the client fails to
register within the specifies interval, the client initiates a request again. If the client
fails to register for the maximum times, the DVPN client enters dumb state.
By default, the interval for the client to register is 10 seconds.
Example
# Set the interval for the client to register to 20 seconds.
[SecBlade_VPN] dvpn client register-interval 20
dvpn client register-retry Syntax
dvpn client register-retry times
undo dvpn client register-retry
View
System view
Parameter
times: Maximum retries for the client to register with a DVPN server continuously.
This argument ranges from 1 to 6.
Description
Use the dvpn client register-retry command to set the maximum retries for a
client to register with a DVPN server continuously.
Use the undo dvpn client register-retry command to revert to the default retries
for a client to register with a DVPN server continuously.
By default, the maximum retries for a client to register with a DVPN server is 3.