3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

26
VRRP CONFIGURATION COMMANDS
n
All the contents below are about SecBlade cards, so the views of the commands in
this manual are the views corresponding to SecBlade cards instead of the Switch
8800 Family switches.
VRRP Configuration
Commands
n
You can also use the following commands with SecBlade_VPN prompt character.
debugging vrrp Syntax
debugging vrrp { packet | state }
undo debugging vrrp { packet | state }
View
User view
Parameter
packet: Enables VRRP packet debugging.
state: Enables VRRP state debugging.
Description
Use the debugging vrrp command to enable VRRP debugging.
Use the undo debugging vrrp command to disable VRRP debugging.
By default, VRRP debugging is disabled.
Example
# Enable VRRP packet debugging.
[SecBlade_FW] debugging vrrp packet
display vrrp Syntax
display vrrp [ interface type number [ virtual-router-ID ] ]
View
Any view