3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

474 CHAPTER 26: VRRP CONFIGURATION COMMANDS
Parameter
interface type number: Specifies an interface type and interface number.
virtual-router-ID: Standby group number.
Description
Use the display vrrp command to view current configuration and state
information about VRRP.
If the interface and standby group number are not specified, the state information
about all the standby groups is displayed. If only the interface is specified, the state
information about all the standby groups on the interface is displayed. If both
arguments are specified, the state information about the specified standby group
is displayed.
Example
# Display information about all standby groups.
<SecBlade_FW> display vrrp
Virtual Ip Ping : Disable
GigabitEthernet0/0.1 | Virtual Router 1
state : Initialize
Virtual IP : 22.2.2.2
Config Priority : 100
Run Priority : 100
Preempt : YES Delay Time : 0
Timer : 1
Auth Type : NONE
GigabitEthernet0/0.2 | Virtual Router 1
state : Initialize
Virtual IP : 1.1.11.1
Config Priority : 100
Run Priority : 100
Preempt : YES Delay Time : 0
Timer : 1
Auth Type : NONE
vrrp
authentication-mode
Syntax
vrrp authentication-mode { md5 key | simple key }
undo vrrp authentication-mode
View
Interface view
Parameter
simple: Adopts plain text authentication.
md5: Adopts ciphertext authentication using the MD5 algorithm.
key: Authentication key. When simple authentication applies, the authentication
key is in plain text with a length of 1 to 8 characters. When md5 authentication
applies, the authentication key is in MD5 ciphertext and the length of the key