3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

478 CHAPTER 26: VRRP CONFIGURATION COMMANDS
undo vrrp vrid virtual-router-ID timer advertise
View
Interface view
Parameter
virtual-router-ID: VRRP standby group number, in the range of 1 to 255.
adver-interval: Interval at which the master in the specified standby group sends
VRRP packets. It is in the range of 1 to 255 in seconds.
Description
Use the vrrp vrid timer advertise command to configure the Adver_Timer of the
specified standby group.
Use the undo vrrp vrid timer advertise command to restore the default.
The Adver_Timer controls the interval at which the master sends VRRP packets.
By default, the value of the timer is 1 second.
Example
# Set the master in standby group 1 to send VRRP packets at intervals of five
seconds.
[SecBlade_FW-GigabitEthernet0/0.1] vrrp vrid 1 timer advertise 5
vrrp vrid track Syntax
vrrp vrid virtual-router-ID track interface-type interface-number [ reduced
priority-reduced ]
undo vrrp vrid virtual-router-ID track [ interface-type interface-number ]
View
Interface view
Parameter
virtual-router-ID: VRRP standby group number, in the range of 1 to 255.
interface-type interface-number: Interface to be tracked.
priority-reduced: Value by which the priority is reduced. It is in the range of 1 to
255.
Description
Use the vrrp vrid track command to configure the interface to be tracked.
Use the undo vrrp vrid track command to disable tracking the specified
interface.
The interface tracking function expands the backup functionality of VRRP. It
provides backup not only when a security gateway fails but also when a network
interface goes down.