3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

52 CHAPTER 4: AAA AND RADIUS/HWTACACS PROTOCOL CONFIGURATION
AAA and
RADIUS/HWTACACS
Protocol
Configuration
Example
Telnet/SSH User
Authentication/Accounti
ng Using RADIUS Server
n
Authentication configuration on the RADIUS server for SSH users and that for
Telnet users is similar. The following uses the configuration for Telnet users as an
example.
Network requirements
Configure the IPsec module to enable the RADIUS server to provide authentication
and accounting services for Telnet users accessing the IPsec module (see the
following figure).
Display the statistics on the local RADIUS
authentication server.
display local-server statistics
Enable RADIUS packet debugging. debugging radius packet
Disable RADIUS packet debugging. undo debugging radius packet
Enable local RADIUS authentication server
debugging.
debugging local-server { all | error | event |
packet }
Disable local RADIUS authentication server
debugging.
undo debugging local-server { all | error |
event | packet }
Clear stop-accounting packets from the
buffer.
reset stop-accounting-buffer {
radius-scheme radius-scheme-name |
session-id session-id | time-range start-time
stop-time | user-name user-name }
Reset the statistics of RADIUS server. reset radius statistics
Tabl e 57 Display and debug the HWTACACS protocol
Operation Command
Display the specified or all the HWTACACS
schemes.
display hwtacacs [ hwtacacs-scheme-name [
statistics ] ]
Display information on the stop-accounting
packets in the buffer.
display stop-accounting-buffer
hwtacacs-scheme hwtacacs-scheme-name
Enable HWTACACS debugging.
debugging hwtacacs { all | error | event |
message | receive-packet | send-packet }
Disable HWTACACS debugging.
undo debugging hwtacacs { all | error |
event | message | receive-packet |
send-packet }
Clear stop-accounting packets from the
buffer.
reset stop-accounting-buffer
hwtacacs-scheme hwtacacs-scheme-name
Reset the statistics about TACACS servers.
reset hwtacacs statistics {accounting |
authentication | authorization | all }
Table 56 Display and debug the RADIUS protocol
Operation Command