H3C S7500 Series Ethernet Switches Command Manual

Command Manual – Infomation Center
H3C S7500 Series Ethernet Switches Chapter 1
Information Center Commands
1-20
1.1.16 info-center trapbuffer
Syntax
info-center trapbuffer [ channel { channel-number | channel-name } | size
buffersize ]*
undo info-center trapbuffer [ channel | size ]
View
System view
Parameters
size: Configures the size of the trap buffer.
buffersize: Size of trap buffer (numbers of messages). This argument ranges from 0 to
1,024 and defaults to 256.
channel: Sets the channel through which information is sent to the trap buffer.
channel-number: Channel number, ranging from 0 to 9, that is, the system has ten
channels.
channel-name: Channel name. By default, the names of channels 0 to channel 9 are
console, monitor, loghost, trapbuffer, logbuffer, snmpagent, channel6, channel7,
channel8, and channel9.
Description
Use the info-center trapbuffer command to enable information output to the trap
buffer.
Use the undo info-center trapbuffer command to disable information output to the
trap buffer.
By default, the system outputs information to the trap buffer, and the size of the trap
buffer is 256.
This command takes effect only after the information center function is enabled.
You can configure the system to output information to the trap buffer by setting the size
of the trap buffer.
Related commands: info-center enable, display info-center.
Examples
# Send information to the trap buffer and set the size of buffer to 30.
<H3C>system-view
System View: return to User View with Ctrl+Z.
[H3C] info-center trapbuffer size 30