H3C S7500 Series Ethernet Switches Command Manual

Command Manual – HWPing
H3C S7500 Series Ethernet Switches Chapter 1
HWPing Commands
1-5
Field Description
Status
Value of the test result. See the following detailed
description:
1: responceReceived. It means response is received.
2: unknown. It means an unknown error.
3: internalError. It means a system internal error.
4: requestTimeOut. It means the response times out.
5: unknownDestinationAddress. It means the destination
address is unknown.
6: noRouteToTarget. It means there is no route to the
destination address.
7: interfaceInactiveToTarget. It means the interface of
destination address is not activated.
8: arpFailure. It means ARP operation fails.
9: maxConcurrentLimitReached. It means the maximum limit
of concurrent accesses is reached.
10: unableToResolveDnsName. It means it is unable to
resolve the DNS field.
11: invalidHostAddress. It means the invalid host address.
LastRC
Receive the last response code based on the
implementation ways. With ICMP echo enabled, if the
system receives ICMP response which includes
ICMP_ECHOREPLY(0), the probe has succeeded. ICMP
response is often defined in the file including ip_icmp.
Time Test time
1.1.4 frequency
Syntax
frequency interval
undo frequency
View
HWPing test group view
Parameters
interval: Automatic test interval. It ranges from 0 to 65,535 seconds and defaults to 0.
The default value means that no automatic test is performed.
Description
Use the frequency command to configure an automatic test interval.
Use the undo frequency command to disable an automatic test.