H3C S7500 Series Ethernet Switches Command Manual

Command Manual – Hardware-Dependent Software Configuration
H3C S7500 Series Ethernet Switches
Chapter 1 Hardware-Dependent
Software Configuration Commands
1-4
receiving the handshake packets, the service cards report the result to the SRPU. In
this case, the SRPU knows that the service cards are operating normally. Through this
process, the SRPU can judge whether each service card in the device operates
normally.
S7500 Ethernet switches support this feature. Through this feature, you can monitor
internal channels.
You can also set the maximum number of times the SRPU fails to receive handshake
packets. If the number of times the SRPU fails to receive handshake packets exceeds
the upper limit, the switch resets the processing chip automatically. When the SRPU
receives handshake packets, it resets the counter automatically.
You can also set whether to restart the service card or the switch when the number of
times the SRPU fails to receive handshake packets exceeds the upper limit.
Examples
# Enable the function of monitoring internal channels
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] monitor inner-channel
1.3.2 monitor inner-channel
Syntax
monitor inner-channel upper-limit upper-timers
undo monitor inner-channel
View
System view
Parameters
upper-times: Specifies the upper limit.
Description
Use the monitor inner-channel upper-limit command to set the maximum number of
times of monitoring internal channels.
Use the undo monitor inner-channel command to disable the function of setting the
maximum number of times of monitoring internal channels.
The default value is 10.
An internal channel refers to the interface channel between the SRPU and the service
cards. The SRPU sends handshake packets to each service card every second. After
receiving the handshake packets, the service cards report the result to the SRPU. In