H3C S7500 Series Ethernet Switches Command Manual

Command Manual – Port Basic Configuration
H3C S7500 Series Ethernet Switches Chapter 1
Port Basic Configuration Commands
1-15
Table 1-5 Range of LPU slot number/subcard slot number/port number
Description
Device
Range of LPU
number
Subcard slot
number
Range of port number
S7502 0 to 1 0
S7503 0 to 3 0
S7506 0 to 6 0
S7506R 0 to 7 0
Depending on the
number of ports on the
LPU you select
Description
Use the interface command to enter Ethernet port view. To configure parameters for a
port, you must use this command to enter Ethernet port view first.
Examples
# Enter GigabitEthernet 2/0/1 port view.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] interface GigabitEthernet2/0/1
[H3C-GigabitEthernet2/0/1]
1.1.15 jumboframe enable
Syntax
jumboframe enable [ jumboframe-value ]
undo jumboframe enable
View
Ethernet port view
Parameters
jumboframe-value: Size of the permitted jumbo frame, in the range of 1,536 to 9,216 in
byte.
Description
Use the jumboframe enable command to allow jumbo frames to pass through the
current Ethernet port.
Use the undo jumboframe enable command to inhibit jumbo frames from passing
through the current Ethernet port.