H3C S7500 Series Ethernet Switches Command Manual

Command Manual – Link Aggregation
H3C S7500 Series Ethernet Switches
Chapter 1 Link Aggregation Configuration
Commands
1-8
View
System view
Parameters
interface-type: Port type.
interface-number: Port number.
to: Specifies a series of contiguous ports.
both: Performs load sharing for both inbound traffic and outbound traffic on all the
member ports in the aggregation group.
Description
Use the link-aggregation command to add a series of ports to a new manual
aggregation group, to which the system assigns a group number automatically. The
link-aggregation group agg-id mode command and the port link-aggregation
group command can be used together to implement the function of the
link-aggregation command.
By default:
z For IP packets, the system performs load sharing based on IP addresses;
z For non-IP packets, the system performs load sharing based on MAC addresses.
Examples
# Set up an aggregation group with Ethernet 2/0/1 to Ethernet 2/0/4 and perform load
sharing for both inbound and outbound traffic of the aggregation group.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] link-aggregation ethernet2/0/1 to ethernet2/0/4 both
1.1.9 link-aggregation group description
Syntax
link-aggregation group agg-id description agg-name
undo link-aggregation group agg-id description
View
System view
Parameters
agg-id: Aggregation group ID, in the range of 1 to 384.
agg-name: Aggregation group name, a string of 1 to 32 characters.