H3C S7500 Series Ethernet Switches Command Manual

Command Manual – Port Isolation
H3C S7500 Series Ethernet Switches
Chapter 1 Port Isolation Configuration
Commands
1-2
Parameters
group-id: ID of an isolation group, in the range 1 to 64.
Description
Use the display isolate port command to display the configuration of a created
isolation group, including:
z ID of the isolation group
z Description string for the isolation group
z Ports that the isolation group contains
Examples
# Display the configuration of isolation group 1.
<H3C> display isolate port group 1
Isolate group ID: 1
Description: home
Isolated port(s) in group 1:
Ethernet2/0/2 Ethernet2/0/3 Ethernet2/0/4
1.1.3 port
Syntax
port interface-list
undo port interface-list
View
Isolation group view
Parameters
interface-list: List of destination ports, expressed in the form of interface-list =
interface-type interface-number [ to interface-type interface-number ] &<1-10>., where:
z The interface-type argument represents the type of the bound port;
z The interface-number argument represents the number of the bound port;
z The to keyword specifies a group of contiguous ports. The port number after the to
keyword must be not smaller than that before the to keyword.
z &<1-10> means that you can provide up to 10 port indices/port index lists for this
argument.
Description
Use the port command to add the specified ports to an isolation group.
Use the undo port command to remove the specified ports from an isolation group.