H3C S7500 Series Ethernet Switches Command Manual

Command Manual – Port Isolation
H3C S7500 Series Ethernet Switches
Chapter 1 Port Isolation Configuration
Commands
1-3
By default, an isolation group contains no Ethernet port.
This command functions the same as the
port isolate group command except that
Ethernet ports must be specified in this command.
Examples
# Add Ethernet 2/0/1 to isolation group 1.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] port-isolate group 1
[H3C-port-isolate-group1] port Ethernet 2/0/1
1.1.4 port isolate group
Syntax
port isolate group group-id
undo port isolate
View
Ethernet port view
Parameters
group-id: ID of an isolation group, in the range 1 to 64.
Description
Use the port isolate group command to add the current Ethernet port to a created
isolation group.
Use the undo port isolate command to remove the current Ethernet port from an
isolation group.
By default, an isolation group contains no Ethernet port.
This command functions the same as the
port command except that Ethernet ports
need not be specified in this command.
 Note:
z An Ethernet port belongs to only one port isolation group. If you add an Ethernet port
to different isolation groups, the port belongs to only the latest isolation group to
which the port is added.
z Currently, cards of Type A (LS81FT48A, LS81FM24A, LS81FS24A, LS81GB8UA,
and LS81GT8UA) do not support the Port Isolation feature.