H3C S7500 Series Ethernet Switches Command Manual

Command Manual – MSTP
H3C S7500 Series Ethernet Switches Chapter 1
MSTP Configuration Commands
1-2
1.1.2 check region-configuration
Syntax
check region-configuration
View
MST region view
Parameters
None
Description
Use the check region-configuration command to display the current MST region
configuration information, including the region name, the revision level, and the VLAN
mapping table.
In an MSTP region, make sure that the MST region-related settings (especially the
VLAN mapping table) are right. MSTP-enabled switches are in the same region only
when they have the same MST region-related settings. A switch cannot be in a
respected region if any one of the above three MST region-related settings is not
consistent with that of another switch in the region.
You can use this command to view inactivated MST region-related settings, according
to which you can find out the MST region the switch currently belongs to or check to see
whether or not the MST region-related configuration is correct.
Related commands: instance, region-name, revision-level, vlan-mapping modulo,
active region-configuration.
Examples
# Display the MST region configuration of the current switch.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] stp region-configuration
[H3C-mst-region] check region-configuration
Admin Configuration
Format selector :0
Region name :00e0fc003900
Revision level :0
Instance Vlans Mapped
0 1 to 9, 11 to 4094
16 10