H3C S7500 Series Ethernet Switches Command Manual

Command Manual – Routing Protocol
H3C S7500 Series Ethernet Switches Chapter 1 Static Route Configuration Commands
1-9
<H3C>system-view
System View: return to User View with Ctrl+Z.
[H3C] ip ip-prefix abc2 permit 10.1.1.0 24 less-equal 32
[H3C] display ip routing-table ip-prefix abc2
Routes matched by ip-prefix abc2:
Summary count: 2
Destination/Mask Protocol Pre Cost Nexthop Interface
10.1.1.0/24 DIRECT 0 0 10.1.1.2 Vlan-interface1
10.1.1.2/32 DIRECT 0 0 127.0.0.1 InLoopBack0
For detailed information about the displayed information above, refer to Table 1-1.
# Display the detailed information about the active and inactive routes filtered through
the ip-prefix list named abc2.
[H3C] display ip routing-table ip-prefix abc2 verbose
Routes matched by ip-prefix abc2:
Generate Default: no
+ = Active Route, - = Last Active, # = Both * = Next hop in use
Summary count: 2
**Destination: 10.1.1.0 Mask: 255.255.255.0
Protocol: #DIRECT Preference: 0
*NextHop: 10.1.1.2 Interface: 10.1.1.2(Vlan-interface1)
Vlinkindex: 0
State: <Int ActiveU Retain Unicast>
Age: 3:23:44 Cost: 0/0 Tag: 0
**Destination: 10.1.1.2 Mask: 255.255.255.255
Protocol: #DIRECT Preference: 0
*NextHop: 127.0.0.1 Interface: 127.0.0.1(InLoopBack0)
Vlinkindex: 0
State: <NoAdvise Int ActiveU Retain Gateway Unicast>
Age: 3:23:44 Cost: 0/0 Tag: 0
For detailed description on the displayed information above, refer to Table 1-2.
1.1.6 display ip routing-table protocol
Syntax
display ip routing-table protocol protocol [ inactive | verbose ]
View
Any view