H3C S7500 Series Ethernet Switches Command Manual

Command Manual – Routing Protocol
H3C S7500 Series Ethernet Switches Chapter 4 Integrated IS-IS Configuration Commands
4-28
Description
Use the log-peer-change command to enable the IS-IS adjacency state change
output.
Use the undo log-peer-change command to disable the output.
The output is disabled by default.
When the adjacency state output is enabled, the IS-IS adjacency state change will be
sent to the configuration terminal.
Examples
# Enable the IS-IS adjacency state change output on the current router.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] isis
[H3C-isis] log-peer-change
4.1.31 md5-compatible
Syntax
md5-compatible
undo md5-compatible
View
IS-IS view
Parameters
None
Description
Use the md5-compatible command to specify IS-IS to adopt the MD5 algorithm
compatible with other manufacturers.
Use the undo md5-compatible command to specify IS-IS to adopt the default MD5
algorithm.
By default, IS-IS adopts the MD5 algorithm compatible with Huawei.
This command must be configured when the switch needs to perform IS-IS MD5
authentication with the devices of manufacturers except Huawei.
Examples
# Specify IS-IS to adopt the MD5 algorithm compatible with other manufacturers.
<H3C> system-view
System View: return to User View with Ctrl+Z.