H3C S7500 Series Ethernet Switches Command Manual

Command Manual – Routing Protocol
H3C S7500 Series Ethernet Switches Chapter 4 Integrated IS-IS Configuration Commands
4-31
Description
Use the reset isis all command to clear all ISIS data structure information.
The IS-IS data information will not be cleared by default.
This command is used when an LSP need to be updated immediately. For example,
after performing the area-authentication-mode and domain-authentication-mode
commands, if the router still has some old LSPs, you can use this command to clear
these LSPs.
Related commands: area-authentication-mode, domain authentication-mode.
Examples
# Clear all IS-IS data structure.
<H3C> reset isis all
4.1.35 reset isis peer
Syntax
reset isis peer system-id
View
User view
Parameters
system-id: System ID for an IS-IS peer, in the range of one bit to 128 bits.
Description
Use the reset isis peer command to clear the data information of a specific IS-IS peer.
The IS-IS peer is not cleared by default.
This command is used when you need to re-establish a specific peer.
Examples
# Clear the IS-IS peer with the system ID as 0000.0c11.1111.
<H3C> reset isis peer 0000.0c11.1111
4.1.36 set-overload
Syntax
set-overload
undo set-overload