H3C S7500 Series Ethernet Switches Command Manual

Command Manual – Routing Protocol
H3C S7500 Series Ethernet Switches Chapter 6 IP Routing Policy Configuration Commands
6-7
egp: Specifies that BGP routing information source is external route.
as-number: Autonomous system number of an external route. The value ranges from 1
to 65,535.
incomplete: Specifies that BGP routing information source is unknown.
Description
Use the apply origin command to set BGP routing information source.
Use the undo apply origin command to cancel the apply clause.
Related commands: if-match interface, if-match acl, if-match ip-prefix, if-match ip
next-hop, if-match cost, if-match tag, route-policy, apply ip next-hop, apply
local-preference, apply cost, apply tag.
Examples
# Define an apply clause to specify that the BGP routing information source is igp.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C]route-policy 10 permit node 10
[H3C-route-policy] apply origin igp
6.1.9 apply tag
Syntax
apply tag value
undo apply tag
View
Route policy view
Parameters
value: Tag value of route information, ranging from 0 to 4,294,967.295.
Description
Use the apply tag command to set the tag area of RIP or OSPF route information.
Use the undo apply tag command to cancel the apply clause.
Related commands: if-match interface, if-match acl, if-match ip-prefix, if-match ip
next-hop, if-match cost, if-match tag, route-policy, apply ip next-hop, apply
local-preference, apply cost, apply origin.
Examples
# Define an apply clause to set the tag area of route information to 100.