H3C S7500 Series Ethernet Switches Command Manual

Command Manual – Routing Protocol
H3C S7500 Series Ethernet Switches Chapter 7 Route Capacity Configuration Commands
7-3
The information displayed above includes Ethernet switch memory limit, size of free
memory, times of disconnection, times of reconnection, and the current status.
The following table describes the fields of the command:
Table 7-2 Description on the fields of the display memory limit command
Field Description
system memory safety Safety value of the switch memory
system memory limit Lower limit of the switch memory
auto-establish enabled
Automatic connection recovery is enabled (If
automatic connection recovery is disabled,
"auto-establish disabled" is displayed)
Free Memory Size of the current free memory in bytes
The times of disconnect: 0 The times of disconnection of the routing protocol is 0.
The times of reconnect: 0 The times of reconnection of the routing protocol is 0.
The current state: Normal
The current status is normal (If the current status is
emergent, "Exigence" is displayed).
7.1.3 memory auto-establish disable
Syntax
memory auto-establish disable
View
System view
Parameters
None
Description
Use the memory auto-establish disable command to disable the automatic recovery
of routing protocol connections (even if the free memory recovers to the safety value).
By default, when the free memory of a switch recovers to the safety value, connections
of all the routing protocols will always recover (when the free memory of the switch
decreases to a lower limit, the connections will be disconnected forcibly).
After this command is used, connections of all the routing protocols will not recover
when the free memory of the switch recovers to a safety value. In this case, you need to
restart the routing protocol to recover the connections.
Use this command with caution.