H3C S7500 Series Ethernet Switches Command Manual

Command Manual – 802.1x
H3C S7500 Series Ethernet Switches Chapter 1
802.1x Configuration Commands
1-20
Description
Use the dot1x version-check command to enable 802.1x client version checking for
the specified Ethernet ports.
Use the undo dot1x version-check command to disable the function for the specified
Ethernet ports.
By default, 802.1x client version checking is disabled on all Ethernet ports.
When being executed in system view, these two commands apply to all Ethernet ports
of the switch if you do not provide the interface-list argument. And if you specify the
interface-list argument, these commands apply to the specified Ethernet ports.
When being executed in Ethernet port view, these two commands apply to the current
Ethernet port only. In this case, the interface-list argument is not needed.
Examples
# Check the version of the 802.1x client upon receiving authentication packets on
Ethernet 3/0/1.
<H3C>system-view
System View: return to User View with Ctrl+Z.
[H3C] interface Ethernet 3/0/1
[H3C-Ethernet3/0/1] dot1x version-check
1.1.16 reset dot1x statistics
Syntax
reset dot1x statistics [ interface interface-list ]
View
User view
Parameters
interface-list: Ethernet port list. You can specify multiple Ethernet ports by providing this
argument in the form of interface-list = { interface-name [ to interface- name] & < 1-10 >.
The interface-name argument is the port index of an Ethernet port and can be specified
in this form: interface-name = { interface-type interface-num }, where interface-type
specifies the type of a port and interface-num identifies the port number. "&<1-10>"
means that up to 10 port indexes/port index lists can be provided.
Description
Use the reset dot1x statistics command to clear 802.1x-related statistics.