H3C S7500 Series Ethernet Switches Command Manual

Command Manual – AAA & RADIUS & HWTACACS & EAD
H3C S7500 Series Ethernet Switches
Chapter 1 AAA & RADIUS & HWTACACS
Configuration Commands
1-50
1) The switch sends a RADIUS packet to the primary RADIUS server.
2) After confirming that no response will be received from the primary server, the
switch starts to send RADIUS packets to the secondary RADIUS server.
3) At the interval of wait time, the switch sets the state of the primary server to active
and sends RADIUS packets to the primary server.
Examples
# Set the wait time for the RADIUS scheme radius1 to 3 minutes.
<H3C>system-view
System View: return to User View with Ctrl+Z.
[H3C] radius scheme radius1
[H3C-radius-radius1] timer quiet 3
1.2.27 timer realtime-accounting
Syntax
timer realtime-accounting minutes
undo timer realtime-accounting
View
RADIUS scheme view
Parameters
minutes: Real-time accounting interval. It ranges from 3 minutes to 60 minutes and
must be a multiple of 3. By default, this interval is 12 minutes.
Description
Use the timer realtime-accounting command to set the real-time accounting interval.
Use the undo timer realtime-accounting command to restore the default real-time
accounting interval.
Note that:
z To charge the users in real time, you should set the interval of real-time accounting.
After the setting, the NAS sends the accounting information of online users to the
RADIUS server at regular intervals.
z The setting of the real-time accounting interval depends to some degree on the
performance of the NAS and the RADIUS server. The higher the performance of
the NAS and the RADIUS server is, the shorter the interval can be. You are
recommended to set the interval as long as possible when the number of users is
relatively great (ú1000).
Table 1-5 lists the numbers of users and the
corresponding recommended intervals.