H3C S7500 Series Ethernet Switches Command Manual

Command Manual – AAA & RADIUS & HWTACACS & EAD
H3C S7500 Series Ethernet Switches
Chapter 1 AAA & RADIUS & HWTACACS
Configuration Commands
1-60
1.3.8 primary accounting
Syntax
primary accounting ip-address [ port ]
undo primary accounting
View
HWTACACS scheme view
Parameters
ip-address: IP address of the server, a valid unicast address in dotted decimal format.
port: Port number of the server, which is in the range 1 to 65,535 and defaults to 49.
Description
Use the primary accounting command to configure a primary TACACS accounting
server.
Use the undo primary accounting command to delete the configured primary
TACACS accounting server.
By default, the IP address of TACACS accounting server is 0.0.0.0.
Note that:
z You cannot assign the same IP address to both primary and secondary accounting
servers; otherwise, unsuccessful operation is prompted.
z If you repeatedly use this command, the latest configuration overwrites the
previous one.
z You can remove an accounting server only when it is not being used by any active
TCP connections, and the removal impacts only packets forwarded afterwards.
Examples
# Configure a primary accounting server.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] hwtacacs scheme test1
[H3C-hwtacacs-test1] primary accounting 10.163.155.12 49
1.3.9 primary authentication
Syntax
primary authentication ip-address [ port ]
undo primary authentication