H3C S7500 Series Ethernet Switches Command Manual

Command Manual – AAA & RADIUS & HWTACACS & EAD
H3C S7500 Series Ethernet Switches
Chapter 1 AAA & RADIUS & HWTACACS
Configuration Commands
1-68
Description
Use the stop-accounting-buffer enable command to enable the switch to buffer the
stop-accounting requests that bring no response.
Use the undo stop-accounting-buffer enable command to disable the switch from
buffering the stop-accounting requests that bring no response.
By default, the switch is enabled to buffer the stop-accounting requests that bring no
response.
Stop-accounting requests are critical to billing and will eventually affect the charges;
they are important for both the users and the ISP. Therefore, the switch should do its
best to transmit them to the HWTACACS accounting server. If the HWTACACS
accounting server does not respond to such a request, the switch should first buffer the
request on itself, and then retransmit the request to the HWTACACS accounting server
until it gets a response, or the maximum number of transmission attempts is reached (in
this case, it discards the request).
Related commands: reset stop-accounting-buffer, hwtacacs scheme, display
stop-accounting-buffer.
Examples
# Enable the switch to buffer the stop-accounting requests that bring no response from
the servers in HWTACACS scheme test1.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] hwtacacs scheme test1
[H3C-hwtacacs-test1] stop-accounting-buffer enable
1.3.18 timer quiet
Syntax
timer quiet minutes
undo timer quiet
View
HWTACACS scheme view
Parameters
minutes: Length of the timer in minutes, in the range of 1 to 255. By default, the primary
server must wait five minutes before it resumes the active state.