H3C S7500 Series Ethernet Switches Command Manual

Command Manual – ACL
H3C S7500 Series Ethernet Switches Chapter 1
ACL Commands
1-10
Table 1-3 Description on the fields of the display time-range command
Field Description
Current time is 14:36:36 4-3-2003
Thursday
The current time of the system.
Time-range : tm1 ( Inactive )
from 08:30 2-5-2005 to 18:00 2-19-2005
Time range tm1. Inactive indicates that
this time range is currently in the inactive
state (while Active indicates that the
time range is in the active state), and the
time range is from 8:30 February 5, 2005
to 18:00 February 19, 2005.
1.1.11 packet-filter
Syntax
The command line format for Type A LPUs:
packet-filter { inbound | outbound } acl-rule [ system-index ]
[ not-care-for-interface ]
undo packet-filter { inbound | outbound } acl-rule [ not-care-for-interface ]
The command line format for non-Type-A LPUs:
packet-filter inbound acl-rule [ system-index ]
undo packet-filter inbound acl-rule
 Note:
Combined activating of IP ACL and Link ACL is supported by non-Type-A LPUs . But
the total number of the characters of the fields defined by IP ACL and Link ACL can not
exceed 32 characters; otherwise the ACLs can not be activated.
View
QoS view
Parameters
inbound: Specifies to filter packets received on the port.
outbound: Specifies to filter packets sent through the port.
acl-rule: Applied ACL rule, which can be a combination of different types of ACL rules.
Table 1-4 and Table 1-6 describe the ACL rule combinations on Type A LPUs and the
corresponding parameter description.
Table 1-5 and Table 1-6 describe the ACL rule
combinations on LPUs other than Type A and the corresponding parameter description.