H3C S7500 Series Ethernet Switches Command Manual

Command Manual – ACL
H3C S7500 Series Ethernet Switches Chapter 1
ACL Commands
1-13
Parameters
all: All ACLs (including those identified by a number or a name).
acl-number: ACL number, ranging from 2000 to 3999.
acl-name: ACL name, contains up to 32 characters, a case insensitive string, which
must start with an English letter (a-z or A-Z), and there should not be a space or
quotation mark in it; the word all is not allowed to use in it (to avoid confusion with the
keyword all).
Description
Use the reset acl counter command to clear ACL statistics.
Table 1-7 The comparison between reset commands of statistics information
Command Function
reset acl counter
Reset the statistics information counted by the ACL which
is referenced by software to filter packets or classify traffic
flows. The case includes: ACL referenced by route policy
function, ACL used for controlling login user, etc.
reset traffic-statistic
Reset statistic information of traffic. This command is
applicable to the ACL which is applied to the hardware of a
switch to filter packets or classify traffic flows. Normally,
this command is used to clear the statistics counted by the
traffic-statistic command.
For details about the reset traffic-statistic and
traffic-statistic commands, refer to the QoS module of
the manual.
Examples
# Clear the statistic information of ACL 2000.
<H3C> reset acl counter 2000
1.1.13 rule (Basic ACL)
Syntax
rule [ rule-id ] { permit | deny } [ source { source-addr wildcard | any } | fragment |
time-range time-name ]*
undo rule rule-id [ source | fragment | time-range ]*
View
Basic ACL view