H3C S7500 Series Ethernet Switches Command Manual

Command Manual – Cluster
H3C S7500 Series Ethernet Switches Chapter 1
Cluster Configuration Commands
1-12
hop number limit to 2, only the switches less than 2 hops away from the switch starting
the topology collection are collected.
Note that this command is only applicable to the topology-collecting device. A broader
collection scope requires more memory of the topology-collecting device.
Examples
# Set the hop count for topology information collection to 5.
<aaa_0.H3C> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.H3C] ntdp hop 5
1.2.6 ntdp timer
Syntax
ntdp timer interval-in-minutes
undo ntdp timer
View
System view
Parameters
interval-in-minutes: Interval (in minutes) to collect topology information, ranging from 0
to 65,535. This argument defaults to 0, which specifies not to collect topology
information.
Description
Use the ntdp timer command to configure the interval to collect topology information.
Use the undo ntdp timer command to restore the default interval.
By default, the interval to collect topology information is 0 minutes, that is, topology
information is not collected periodically.
A switch collects topology information once in each period set by the ntdp timer
command.
Examples
# Set the interval to collect topology information to 30 minutes.
<aaa_0.H3C> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.H3C] ntdp timer 30