H3C S7500 Series Ethernet Switches Command Manual

Command Manual – Cluster
H3C S7500 Series Ethernet Switches Chapter 1
Cluster Configuration Commands
1-16
Description
Use the administrator-address command to set the MAC address of the management
device on a member device.
Use the undo administrator-address command to remove a member device from the
cluster.
By default, a switch belongs to no cluster.
In order that the member devices identify the management device correctly after the
system is restarted, the administrator-address command is enabled automatically on
the switch to specify the MAC address of the management device in the cluster when
the switch is added to the cluster as a member device.
Note that the undo administrator-address command is generally used in debugging
or restoration. You are recommended to use the delete-member command to remove
a cluster member from a cluster on the management device.
Examples
# Remove a member device from the cluster.
<aaa_1.H3C> system-view
System View: return to User View with Ctrl+Z
[aaa_1.H3C] cluster
[aaa_1.H3C-cluster] undo administrator-address
1.3.3 auto-build
Syntax
auto-build [ recover ]
View
Cluster view
Parameters
recover: Establishes communication with all the member devices again.
Description
Use the auto-build command to add the candidate device to the cluster automatically
to be a member device.
This command can be executed on a management device or a device to be configured
as a management device.
When you use this command on a candidate device, you will be required to enter the
cluster name and build a cluster. The system will collect candidate devices