H3C S7500 Series Ethernet Switches Command Manual

Command Manual – Cluster
H3C S7500 Series Ethernet Switches Chapter 1
Cluster Configuration Commands
1-20
Examples
# Enable the cluster function on a switch.
<H3C> system-view
System View: return to User View with Ctrl+Z
[H3C] cluster enable
1.3.7 cluster switch-to
Syntax
cluster switch-to { member-number | mac-address H-H-H | administrator }
View
User view
Parameters
member-number: Member number of a switch in a cluster, ranging from 1 to 255.
H-H-H: Specifies the MAC address of a member device.
administrator: Switches from a member device to the management device.
Description
Use the cluster switch-to command to switch between the management device and
member devices for configuration and management.
You can manage member devices in a cluster through the management device, on
which you can switch to member view to configure or manage specified member
devices, and then use the quit command to return to the management device.
z Once a candidate switch is added to a cluster as a member switch, its level-3 user
password will be replaced by the password of the management device.
Authentication is not required when you switch from the management device to
the member device.
z When you switch from the member device to the management device, you can
user the level-1 user authority only. When the super command is used and the
level-3 user password is provided, you can use the level-3 user authority.
When you execute this command on the management device with the member-number
argument provided, an error occurs if the member device identified by the
member-number argument does not exist. You can enter quit to cancel the switchover
operation.
Examples
# Switch from the management device to the member device numbered 6 and then
switch back to the management device.