H3C S7500 Series Ethernet Switches Installation Manual

Installation Manual
H3C S7500 Series Ethernet Switches Chapter 7 Software Maintenance
7-16
The backup app to boot of board 0 is: flash:/S7506R001.app
The app to boot of board 0 at this time is: flash:/S7506R001.app
4) Load the Boot ROM and host software to the standby SRPU.
z Copy the Boot ROM and host software from active SRPU to the standby one.
<H3C> copy S7506R002.app slot1#flash:/S7506R002.app
z Specify the newly loaded Boot ROM and host software as the Boot ROM and host
software of the standby SRPU.
<H3C> boot bootrom SRPUbtm.app slot 1 (Skip this if Boot ROM loading is not required.)
<H3C> boot boot-loader primary S7506R002.app slot 1
<H3C> boot boot-loader backup S7506R001.app slot 1
<H3C> display boot-loader
The primary app to boot of board 0 at the next time is: flash:/S7506R002.app
The backup app to boot of board 0 is: flash:/S7506R001.app
The app to boot of board 0 at this time is: flash:/S7506R001.app
The primary app to boot of board 1 at the next time is: flash:/S7506R002.app
The backup app to boot of board 1 is: flash:/S7506R001.app
The app to boot of board 1 at this time is: flash:/S7506R001.app
5) Restart the system.
<H3C> reboot
II. Loading using TFTP
Loading using TFTP is similar to loading using FTP, except that the protocol used for
downloading is TFTP. In this case, the switch can only be used as a TFTP client to
download the software to its Flash from the TFTP server. After the downloading is
completed, the remaining procedure is the same as that in the case of loading using
FTP.
7.4.2 Loading through the BOOT Menu
To load a Boot ROM and host software to the active and standby SRPUs of the S7506R
through the BOOT menu, you can use the same loading method for the switches that
only support a single SRPU, as described in section
7.2 “Loading Software Through
the Boot Menu” on page
7-1.
Note that:
z You are recommended to use two HyperTerminals to connect the console ports of
active and standby SRPUs. In this way, you can load Boot ROM and host software
to active and standby SRPUs simultaneously. After loading, reboot the system, or
reboot the active and standby SRPUs separately.
z If only one HyperTerminal is available, you can load the Boot ROM and host
software to the active SRPU and reboot it. Then connect the HyperTerminal to the
console port of the standby SRPU, load the Boot ROM and host software to the
standby SRPU, and then reboot it.