H3C S7500 Series Ethernet Switches Installation Manual

Installation Manual
H3C S7500 Series Ethernet Switches Chapter 7 Software Maintenance
7-18
2. 1972 SWITCH100.cfg
3. 1012 taskswitch.log
4. 631736 Btm530.btm
5. 199696 8241btm.app
6. 2427 cfg.txt
7. 6048565 SWITCH200.app
8(*). 5639172 SWITCH000.app
9(-). 203460 SWITCH100.app
The current application file is :SWITCH000.app
The backup application file is : SWITCH100.app
Free Space : 471040 bytes
The system shows all files in the Flash memory, wherein the one with an asterisk (*) is
the primary file and the one with a hyphen (-) is the backup file.
3) Re-configure the primary and backup files.
z Set the primary file.
Enter the serial number of the desired primary file when the terminal displays the
following information:
Please input the primary application file number to boot :9
Press Enter and the terminal displays the primary file name you have chosen. Type Y
to confirm the choice or N to reset.
The primary file you selected is SWITCH100.app, are you sure? Yes or No(Y/N):Y
If you enter Y, the terminal displays the following information:
On reboot, SWITCH100.app will become the default primary application file to
boot!
This means the primary file has been set successfully.
z Set the backup file.
You can set the backup file almost in the way you set the primary file. The terminal
displays the following information:
Please input the backup application file number :7
The file you selected is SWITCH200.app, are you sure? Yes or No(Y/N)y
On reboot,SWITCH200.app will become the backup application file to boot!
4) Decide whether to run the primary file immediately. If you type Y and press Enter,
the system begins to reboot.
Do you want to run SWITCH100.app now?Yes or No(Y/N)?Y
press Ctrl+B to enter Boot Menu... 5
Auto-booting....................
One of the following cases may occur when the system is rebooted:
z The primary file is correct and the system boots with the primary file.