H3C S7500 Series Ethernet Switches Installation Manual

Installation Manual
H3C S7500 Series Ethernet Switches Appendix A B68-22 Cabinet Installation
A-24
(1) M12 stud, 60 mm (2.36 in) long (2) M12 spring washer
(3) M12 flat washer (4) Expansion tube
(5) Expansion nut (6) Height-retaining bolt (both sides)
(7) Height-retaining bolt (both sides) (8) Silkscreen of antistatic floor height
Figure A-26 Fix a rack onto the floor.
Caution:
In Figure A-26, when fixing a rack, fasten the retaining bolt in the middle first and then
those at the two sides.
A.3.6 Installing the Slide Rails
I. Installing T-shape nuts
Before installing a pair of rails, put T-shape nuts into their downside troughs, four for
each rail. Two of these nuts are used for fixing the rail and another two are for fixing the
floor pallet assemblies. This must be done before installing rails; after that, you are
unable to install the nuts. Each cabinet is equipped with four sets of brackets for fixing
floor pallets, two for each rail.