H3C S7500 Series Ethernet Switches Installation Manual

Installation Manual
H3C S7500 Series Ethernet Switches Appendix A B68-22 Cabinet Installation
A-30
(1) Cabinet retaining nut (2) Cabinet foot
(3) Anchor strip retaining nut (4) Downside of the cabinet
Figure A-33 Lock cabinet feet
A.3.9 Combining Cabinets
If two (and more than two) cabinets are used, follow these steps to connect them
together.
1) Remove the cabinet covers as shown in
Figure A-34.
2) Rotate the combining brackets on top of the cabinets by 180 degrees, tighten them,
and connect the cabinets with flat washers, spring washers, bolts and nuts, as
shown in
Figure A-35.
3)
Figure A-34 illustrates the original position of the combining brackets and Figure
A-35 illustrates the position after they are rotated.