H3C S7500 Series Ethernet Switches Installation Manual

Installation Manual
H3C S7500 Series Ethernet Switches Appendix A B68-22 Cabinet Installation
A-32
Caution:
After you combine the cabinets, replace the removed covers.
A.3.10 Fixing Cabinets
I. Installing T-shape nuts
Before fixing a cabinet, put T-shape nuts into the upper troughs of the slide rails, two on
each side. (Each anchor strip needs two T-shape nuts).
II. Installing anchor strips
As shown in Figure A-36, install the anchor strips. One chassis needs two anchor
strips.
Caution:
The anchor strip must be installed in the orientation as shown in Figure A-36.