H3C S7500 Series Ethernet Switches Installation Manual

Installation Manual
H3C S7500 Series Ethernet Switches Appendix B N68 Cabinet Installation
B-58
Side panels are necessary for both ends of a row of cabinets. Side panels fall in left
ones and right ones. A pair of side panels needs to be installed at both ends of a row of
cabinets. They are installed at both sides of the cabinet columns.
Figure B-55 shows the installation of a side panel. The following table describes the
operation procedures:
Table B-14 Install a side panel
Step Operation
1
Loosen M6 bolts used to connect the side panel on the cabinet column,
and then put the side panel between the door lintel and the column.
2
Set the socket of the side panel onto the pin (M6 bolt) from above the pin,
and then install the side panel into the open socket of the installation rack.
3
Align the side panel with the installation holes, and then fasten four M6
countersunk screws to fasten the side panel with a flathead screwdriver.
Pin
M6 countersunk screw
Socket
Cabinet column
Pin
M6 countersunk screw
Socket
Cabinet column
Figure B-55 Install a side panel
4) Install front and back doors
Front doors and back doors are the same. They are of the dual-door structure.
Figure B-56 shows the installation of a front/back door. The following table describes
the operation procedures: