H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – VLAN
H3C S7500 Series Ethernet Switches Chapter 2
VLAN Configuration
2-9
To do… Use the command… Remarks
Enter system view
system-view
—
Create protocol-based
VLAN on specific card
protocol-vlan vlan vlan-id
{ protocol-index [ to
protocol-end ] | all } { slot
slot-number | mainboard }
Required
Caution:
z It is necessary to add those ports that require protocol on the card to the
protocol-based VLAN.
z Currently, only non-type-A cards, including LPUs and SRPUs, support this
command.
z If a protocol-based VLAN has been associated with a card, the VLAN cannot be
removed.
z If a protocol in a VLAN has been associated with a card, the protocol cannot be
removed from the VLAN.
Table 2-2 shows the supported protocol-based VLAN creation commands on different
cards.
Table 2-2 Protocol-based VLAN creation commands on different cards
Command description Type-A card Non-type-A card
Create protocol-based
VLAN on specific card in
system view.
Not supported
Supported (only for all IP protocols
and subnet IP protocols.
Create protocol-based
VLAN on specific port in
Ethernet port view.
Supported
Supported (exclude all IP protocols
and subnet IP protocols.
 Note:
Type A cards include LS81FT48A, LS81FM24A, LS81FS24A, LS81GB8UA,
LS81GT8UA, iSalience I, Salience I and Salience II.