H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Overview
H3C S7500 Series Ethernet Switches Chapter 3
Product Overview
3-6
Module Features supported
09- Port Basic
configuration
z Three port states: access, trunk, hybrid
z Global broadcast suppression on ports
z Loopback detection
z Cable test
10-Link
Aggregation
LACP (link aggregation control protocol)
11-Port Isolation Port isolation group configuration
12-Port Binding MAC address-to-port binding
13-DLDP DLDP (device link detection protocol)
14-MAC Address
Table
z Manually configuring dynamic/static MAC address entries
z Configuring the aging time of MAC address entries
z Configuring the maximum number of MAC addresses that
can be learned on a port
z Inter-chip synchronization of MAC address entries
15-MSTP
z STP (spanning tree protocol)/RSTP (rapid STP)/MSTP
(multiple STP)
z QinQ BPDU tunneling
z H3C's MSTP path cost standard
16-Routing
Protocol
z Static routing
z RIP (routing information protocol) v1/v2
z OSPF (open shortest path first)
z BGP (border gateway protocol)
z IS-IS (intermediate system-to-intermediate system)
z Route policy
17-Multicast
z IGMP Snooping (internet group management protocol
snooping)
z IGMP (internet group management protocol)
z PIM-DM (protocol-independent multicast-dense mode)
z PIM-SM (protocol-independent multicast-sparse mode)
18-802.1x
z 802.1x authentication
z Guest VLAN
z HABP (Huawei authentication bypass protocol)
19-AAA-RADIUS-H
WTACACS-EAD
z AAA (authentication, authorization and accounting)
z RADIUS (remote authentication dial-in user service)
z HWTACACS (Huawei terminal access controller access
control system)
z EAD (endpoint admission defense)
20-Traffic
Accounting
Only supported by the LS81VSNP service card
21-VRRP-HA
z VRRP (virtual router redundancy protocol)
z HA (high availability)