H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – IP Address-IP Performance-IPX
H3C S7500 Series Ethernet Switches Chapter 3
IPX Configuration
3-3
To do… Use the command… Remarks
Configure an IPX
network number for
the VLAN interface
ipx network network
Required
By default, the system does not
assign network numbers to VLAN
interfaces. That is, IPX is disabled
on all VLAN interfaces.
 Note:
z After the undo ipx enable command is executed, the IPX configurations are
removed and cannot be recovered using the ipx enable command.
z After IPX is enabled, you must assign a network number to a VLAN interface to
enable IPX on this VLAN interface. One network number can be assigned to only
one VLAN interface.
z If the IPX network number of a VLAN interface is deleted, the IPX configuration and
static routing information of this VLAN interface will be deleted at the same time.
3.2.3 Configuring IPX Routing
I. Configuring IPX static routes
Follow these steps to configure IPX static routes:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable IPX
ipx enable
Required
Disabled by default.
Enter VLAN interface view
interface Vlan-interface
vlan-id
—
Configure an IPX network
number for the VLAN
interface
ipx network network
Required
By default, the system
does not assign network
numbers to VLAN
interfaces. That is, IPX is
disabled on all VLAN
interfaces.
Exit VLAN interface view
quit
—
Configure IPX static
routes
ipx route-static network
network.node
[ preference value ] [ tick
ticks hop hops ]
Optional
The IPX static routes
whose destination
network number is
0xFFFFFFFE are default
routes.