H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – IP Address-IP Performance-IPX
H3C S7500 Series Ethernet Switches Chapter 3
IPX Configuration
3-10
To do… Use the command… Remarks
Configure an IPX network
number for the VLAN
interface
ipx network network
Required
By default, the system
does not assign network
numbers to VLAN
interface. That is, IPX is
disabled on all the VLAN
interfaces.
Enable triggered update
of IPX
ipx update-change-only
Optional
By default, triggered
update of IPX is disabled.
Enable split horizon of IPX ipx split-horizon
Optional
By default, split-horizon is
enabled.
Configure the
encapsulation format of
the IPX frame
ipx encapsulation [ dot2
| dot3 | ethernet-2 |
snap ]
Optional
By default, the
encapsulation format of
the IPX frame is 802.3
(dot3)
Enable the forwarding of
Type 20 broadcast
packets
ipx netbios-propagation
Optional
By default, Type 20
broadcast packets are not
forwarded.
3.3 Displaying and Maintaining IPX Configuration
To do… Use the command… Remarks
View the information of
IPX on the VLAN interface
display ipx interface [ Vlan-interface
vlan-id ]
View the IP packet
statistics
display ipx statistics
View the IPX service
information table
display ipx service-table [ inactive |
name name | network network | order
{ network | type } | type service-type ]
[ verbose ]
View the IPX routing
information
display ipx routing-table [ network
[ verbose ] | protocol { default | direct |
rip | static } [ inactive | verbose ] |
statistics | verbose ]
Available in
any view
Clear the IPX statistics
reset ipx statistics
Clear the IPX routing table
information
reset ipx routing-table statistics
protocol { all | default | direct | rip |
static }
Available in
user view