H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – GVRP
H3C S7500 Series Ethernet Switches Chapter 1
GVRP Configuration
1-5
To do… Use the command… Remarks
Enter system view
system-view
—
Configure the
LeaveAll timer
garp timer leaveall
timer-value
Optional
By default, the LeaveAll timer is
set to 1,000 centiseconds.
Enter Ethernet port
view
interface interface-type
interface-number
—
Configure the Hold,
Join, and Leave
timers
garp timer { hold | join
| leave } timer-value
Optional
By default, the Hold, Join, and
Leave timers are set to 10, 20,
and 60 centiseconds
respectively.
Exit and return to
system view
quit
—
Enable GVRP
globally
gvrp
Required
By default, GVRP is disabled
globally.
Enter Ethernet port
view
interface interface-type
interface-number
—
Enable GVRP on the
port
gvrp
Required
By default, GVRP is disabled on
the port.
After you enable GVRP on a trunk
port, you cannot change the port
to a different type.
Configure GVRP
port registration
mode
gvrp registration
{ fixed | forbidden |
normal }
Optional
You can choose one of the three
modes.
By default, GVRP port
registration mode is normal.
The timeout ranges of the timers vary depending on the timeout values you set for other
timers. If you want to set the timeout time of a timer to a value out of the current range,
you can set the timeout time of the associated timer to another value to change the
timeout range of this timer.
The following table describes the relations between the timers: