H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Port Basic Configuration
H3C S7500 Series Ethernet Switches Chapter 1
Port Basic Configuration
1-1
Chapter 1 Port Basic Configuration
When configuring port basic configuration, go to these sections for information you are
interested in:
z Ethernet Port Configuration
z Ethernet Port Configuration Example
z Troubleshooting Ethernet Port Configuration
1.1 Ethernet Port Configuration
1.1.1 Initially Configuring a Port
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type
interface-number
—
Enable the Ethernet
port
undo shutdown
Optional
By default, the port is enabled.
Use the shutdown command
to disable the port.
Set the description
of the Ethernet port
description text
Optional
By default, no description is
defined for the port.
Set the duplex mode
of the Ethernet port
duplex { auto | full | half }
Optional
By default, the duplex mode of
the port is auto
(auto-negotiation).
Set the speed of the
Ethernet port
speed { 10 | 100 | 1000 |
10000 | auto }
Optional
By default, the speed of the
port is auto (auto-negotiation).
Set the medium
dependent interface
(MDI) attribute of the
Ethernet port
mdi { across | auto |
normal }
Optional
Be default, the MDI attribute of
the port is auto.
Allow jumbo frames
to pass through the
Ethernet port
jumboframe enable
[ jumboframe-value ]
Optional
By default, jumbo frames that
are larger than 1518 bytes and
smaller than 1536 bytes are
allowed to pass through the
port.