H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Port Basic Configuration
H3C S7500 Series Ethernet Switches Chapter 1
Port Basic Configuration
1-6
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Enable the system to test the
cable connected to the port
virtual-cable-test
Required
1.1.7 Configuring the Interval to Perform Statistical Analysis on Port Traffic
By performing the following configuration, you can set the interval to perform statistical
analysis on the traffic of a port.
When you use the display interface interface-type interface-number command to
display the information of a port, the system displays the average rates of the traffic flow
passing through the port during the specified interval. For example, if you set this
interval to 100 seconds, the displayed information is as follows:
Last 100 seconds input: 0 packets/sec 0 bytes/sec
Last 100 seconds output: 0 packets/sec 0 bytes/sec
Follow these steps to set the interval to perform statistical analysis on port traffic:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Set the interval to perform
statistical analysis on port
traffic
flow-interval interval
Optional
By default, this interval is
300 seconds.
1.1.8 Setting Speedup for a Port
Follow these steps to set speedup for a port:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the hardware
speedup function inside
the port
hardspeedup enable
Disable the hardware
speedup function inside
the port
hardspeedup disable
Optional
By default, the hardware
speedup function inside
the port is enabled.