H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Port Basic Configuration
H3C S7500 Series Ethernet Switches Chapter 1
Port Basic Configuration
1-7
To do… Use the command… Remarks
Enable the hardware
speedup function outside
the port
speedup enable
Disable the hardware
speedup function outside
the port
speedup disable
Optional
By default, the hardware
speedup function outside
the port is enabled.
Caution:
z The hardspeedup enable/disable commands are applicable to type-A LPUs only,
including LS81FT48A, LS81FM24A, LS81FS24A, LS81GB8UA, and LS81GT8UA.
z The speedup enable/disable commands are applicable to non-type-A LPUs only.
z The commands above are diagnostic, so you cannot use them at discretion.
1.1.9 Displaying and Maintaining Basic Port Configuration
To do… Use the command… Remarks
Display port configuration
information
display interface
[ interface-type |
interface-type
interface-number ]
Display the information
about port loopback
detection
display
loopback-detection
Display brief information
about port configuration
display brief interface
[ interface-type
interface-number ] [ |
{ begin | include |
exclude } string ]
Display the hybrid or trunk
ports
display port { hybrid |
trunk }
Display port information
about the specified unit
display unit unit-id
interface
Available in any view.
Clear port statistics
reset counters interface
[ interface-type |
interface-type
interface-number ]
Available in user view.
After 802.1x is enabled on
a port, statistics on the
port cannot be cleared by
the command.