H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – DLDP
H3C S7500 Series Ethernet Switches Chapter 1
DLDP Configuration
1-10
1.3 DLDP Configuration
1.3.1 Configuring DLDP
 Note:
For a port with DLDP enabled, you are not recommended to execute the port monitor
last command on the port. If it is necessary, the value argument in this command must
be less than 10.
Follow these steps to configure DLDP:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable DLDP
globally
dldp enable
Enter
Ethernet
port view
interface interface-type
interface-number
Enable
DLDP
Enable
DLDP
on a
port
Enable
DLDP on
a port
dldp enable
Required.
Enable DLDP
globally and
then enable
DLDP on the
specified port.
Set the authentication mode and
password
dldp authentication-mode
{ none | simple
simple-password | md5
md5-password }
Optional
By default, the
authentication
mode is none,
that is,
authentication
is not
performed.
Set the interval of sending DLDP
packets
dldp interval value
Optional. By
default, the
interval of
sending DLDP
packets is 5
seconds.
Set the delaydown timer
dldp delaydown-timer
delaydown-time
Optional
By default, the
delaydown
timer expires
after 1 second
it is triggered.