H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – DLDP
H3C S7500 Series Ethernet Switches Chapter 1
DLDP Configuration
1-11
To do… Use the command… Remarks
Set the DLDP handling mode
when an unidirectional link is
detected
dldp
unidirectional-shutdown
{ auto | manual }
Optional
By default, the
handling mode
is auto
Set the operating mode of DLDP
dldp work-mode { enhance
| normal }
Optional
By default,
DLDP works in
normal mode.
Enter Ethernet port view
interface interface-type
interface-number
—
Force the duplex attribute
duplex full
Required
If you want to
use DLDP to
detect which
fiber of the two
fibers is not
connected or
fails, you must
configure the
ports to work in
the mandatory
full duplex
mode.
Force the speed value
speed speed-value
Required
Display the configuration
information about the
DLDP-enabled ports
display dldp [ interface-type
interface-number ]
—