H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – CLI
H3C S7500 Series Ethernet Switches Chapter 1
CLI Overview
1-3
1.2.2 Configuring the Level of a Specific Command in a Specific View
You can configure the level of a specific command in a specific view. Commands fall
into four command levels: visit, monitor, system, and manage, which are identified as 0,
1, 2, and 3 respectively. The administrator can change the command level to which a
command belongs.
Follow these steps to configure the level of a specific command in a specific view:
To do... Use the command... Remarks
Enter system view
system-view
—
Configure the level
of a specific
command in a
specific view
command-privilege
level level view view
command
Required
Use this command with cautions
to prevent inconvenience on
maintenance and operation.
1.2.3 CLI Views
CLI views are designed for different configuration tasks. They are interrelated. You will
enter user view once you log into a switch successfully, where you can perform
operations such as displaying operation status and statistical information. And by
executing the system-view command, you can enter system view, where you can
enter other views by executing the corresponding commands.
The following CLI views are provided:
z User view
z System view
z M-Ethernet interface view
z Ethernet port view
z Null interface view
z Tunnel interface view
z VLAN view
z VLAN interface view
z Loopback interface view
z Local user view
z User interface view
z FTP client view
z SFTP client view
z Cluster view
z DHCP address pool view
z MST region view
z RRPP domain view
z MSDP region view
z Port-isolate-group view