H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – MSTP
H3C S7500 Series Ethernet Switches Chapter 1
MSTP Configuration
1-24
2) Configure in Ethernet port view.
<H3C> system-view
[H3C] stp enable
[H3C] interface ethernet2/0/1
[H3C-Ethernet2/0/1] stp disable
1.3 Leaf Node Configuration
Complete the following tasks to configure leaf node:
Task Remarks
MSTP Configuration
Required
To prevent network topology jitter
caused by other related configurations,
you are recommended to enable MSTP
after performing other configurations.
MST Region Configuration Required
MSTP Operation Mode Configuration Optional
Timeout Time Factor Configuration Optional
Maximum Transmitting Speed
Configuration
Optional
The default value is recommended.
Edge Port Configuration Optional
Path Cost Configuration Optional
Port Priority Configuration Optional
Point-to-point Link-Related
Configuration
Optional
 Note:
In a network that contains switches with both GVRP and MSTP employed, GVRP
packets are forwarded along the CIST. If you want to broadcast packets of a specific
VLAN through GVRP, be sure to map the VLAN to the CIST when configuring the
MSTP VLAN mapping table (the CIST of a network is the MSTI numbered 0.)
1.3.1 Configuration Prerequisites
The status of the switches in the spanning trees is determined. That is, the status (root,
branch, or leaf) of each switch in each MSTI is determined.