H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches Chapter 2 Static Route Configuration
2-3
 Note:
z If the destination IP address and the mask of a route are both 0.0.0.0, the route is
the default route. Any packet for which the router fails to find a matching entry in
the routing table will be forwarded through the default route.
z Do not configure the next hop address of a static route as the IP address of an
interface on the local switch.
z The preference can be configured differently to implement flexible route
management policy.
2.3 Displaying the Routing Table
To do... Use the command... Remarks
Display routing table
summary
display ip routing-table
Display routing table
details
display ip routing-table verbose
Display the detailed
information of a specific
route
display ip routing-table
ip-address [ mask ]
[ longer-match ] [ verbose ]
Display the routes in a
specified address range
display ip routing-table
ip-address1 mask1 ip-address2
mask2 [ verbose ]
Display the routes fount
after specified ACL
filtering
display ip routing-table acl
acl-number [ verbose ]
Display the routes found
after specified prefix list
filtering
display ip routing-table ip-prefix
ip-prefix-name [ verbose ]
Display the routes
discovered by a specified
protocol
display ip routing-table protocol
protocol [ inactive | verbose ]
Display the
tree-structured routing
table information
display ip routing-table radix
Display the statistics of
the routing table
display ip routing-table statistics
Available in any
view