H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches Chapter 3 RIP Configuration
3-3
Task Remarks
Enable RIP and specify networks Required
Set the RIP operating status on an interface Optional
Configuring
Basic RIP
Functions
Specify the RIP version on an interface Optional
Set the additional routing metrics of an
interface
Optional
Configure RIP route summarization Optional
Disable the receiving of host routes Optional
Configure inbound/outbound route filtering
policies
Optional
Set RIP preference Optional
Enable RIP traffic sharing Optional
Configuring RIP
Route Control
Configure RIP route redistribution Optional
Configure RIP timers Optional
Configure split horizon Optional
Configure RIP-1 packet zero field check Optional
Set RIP-2 packet authentication mode Optional
RIP Network
Adjustment and
Optimization
Configure a RIP neighbor Optional
3.3 Basic RIP Configuration
3.3.1 Configuration Prerequisites
Before configuring basic RIP functions, perform the following tasks:
z Configuring the link layer protocol
z Configuring IP address on each interface, and make sure that all adjacent nodes
are reachable with each other
3.3.2 Configuring Basic RIP Functions
I. Enable RIP and specify networks
Follow these steps to enable RIP globally and on the interface of a specified network
segment: